Right Sub Menu
PIZO - Allows the piezo bleeper to be turned o when not required by
selecting “n”, selecting “Y” will turn the vario’s tones back on. Select “A”
to allow the tones to turn on automatically if barometric pressure changes
by more than 1mB. This will silence the vario until you begin ying.
AVERAGER SETTING - Allows the averaging display to be set between
1- 60 seconds.
SENSITIVITY - Sets the sensitivity of the vario scale. On the secondary
scale, petals reduce from the centre of the display as the rate of climb/
descent increases.
Setting Petal sensitivity Full scale Secondary scale
11 5 mm/s 50 mm/s 0.1 m/s
10 10 mm/s 0.1 m/s 0.2 m/s DEMO setting
9 20 mm/s 0.2 m/s 0.4 m/s
8 50 mm/s 0.5 m/s 1 m/s ^ More sensitive
7 0.1 m/s 1 m/s 2 m/s
6 0.2 m/s 2 m/s 4 m/s DEFS (Flying defaults)
5 0.5 m/s 5 m/s 10 m/s Thermal ying
4 1 m/s 10 m/s 20 m/s General Aviation
3 2 m/s 20 m/s 40 m/s
2 4 m/s 40 m/s 80 m/s v Less sensitive
1 5 m/s 50 m/s 100 m/s
To Next Page
Loading...