ENGLISH
18
The lter eciently removes food particles from the wash water, allowing it to be re-
cyclated during the cycle. For best performance and results, the lter assembly must be
regularly. For this reason, it is a good idea to remove the larger food particles trapping
in the lter after each wash cycle by rinsing the lter and cup under running water.
To remove the lter assembly, pull on the cup handle in the upward direction.
Inspect the lters for blocking every time the dishwasher has been used.
By unscrewing the coarse lter. you can remove the lter system. Remove
any food remnants and clean the lters under running water.
WARNING: Never run the dishwasher without the lters in place. The dishwasher
must never be used without the lters. Improper replacement of the lter may
reduce the performance level of the appliance and damage dishes and utensils.
Step 1: Contrarotate the
lter assembly (A, B and
C). Then lift it all up.
Step 2: Lift B and C up from A.
The end.
NOTE: If do it from Step 1 to Step 3, the lter system will be removed;. If
you do it from Step 3 to Step 1, the lter system will be installed.
NOTE: The entire lter assembly should be cleaned once a week.
To Next Page
Loading...
