ENGLISH
9
• Before washing, check all pockets to make sure any objects
are out to avoid damaging washer or clothes.
• Never splash water on the control panel.
SELECTING A LOCATION
Before you install the portable washer, select a location with the following characteristics:
• A hard level surface
• Away from direct sunlight
• Adequate ventilation
• Away from sources of heat such as gas or coal. Make sure
washing machine does not stand on power cord.
• Ventilation openings must not be obstructed by carpeting when the portable washer is
installed on a carpeted oor. It is recommended that you place your washer on a hard material.
INSTALLING THE NOISE DAMPER PLATE
1. Take the noise proof plate out of the package.
2. The opening of the noise proof plate is at the bottom of the machine.
3. Lay down the machine gently and insert the noise proof
plate into the washing machine base.
4. Connect the noise proof plate by using the two screws provided.
CONNECTING THE WATER INLET HOSE
The water inlet hose must be connected to the washing machine
at one end and to the faucet at the other. Do not stretch the water
supply hose. If the hose is too short and you do not wish to move the
water faucet, replace the hose with a longer, high-pressure hose.
Use the faucet adapter provided to connect to the faucet. If
adapter does not t, you will have to visit your local hardware
store to nd the one that ts. The end of the faucet spout
should be longer than 10 mm (0.4 inches) or the connector
cannot be xed properly. Water leakage could develop.
NOTE: Plumbing tape (not included) is
recommended for a better seal.
To Next Page
Loading...
Need help?
General