C.
Adjustments
C.1.
Seed and Fertilizer (Spread Amount) Spread Norm Adjustment
The determination of the amount of seed and fertilizer
that you desire to use for unit area during seeding is
referred as spread norm adjustment. Your grain drill is
intended to spread the desired amount of seed and
fertilizer between 2kg and 400 kg per hectare with high
precision.
In order to adjust the desired seed and fertilizer amount,
the funnel trays should be switched to calibration
position, the hopper adjustments should be completed
and finally calibration should be performed, respectively.
The detailed information on these procedure steps are
listed below.
C.1.1. Switching the Funnel Trays to Test Position
1.
Funnel Tray
2.
Funnels
3.
Test Container
4.
Test Container Slot
5.
Jack
6.
Lifting Arm Main Parts of Funnel Tray
To Next Page
Loading...