2
ASSEMBLY INSTRUCTIONS
Please keep these instructions for future reference. Adult assembly required.
This table is not a toy & is intended for use by or under the supervision of adults.
Please do not sit, climb or lean on the table.
A waterproof cover (sold separately) will enhance the life of the table if it is to be used outside
all year round.
Parts Identifier
1. Find a clean & level place to begin the assembly of your SKY table football game. You will
need a Phillips screwdriver, a 13mm spanner & a hammer. Remove all parts from the box &
save all packing materials until the parts have been inspected & the table is assembled.
2. Attaching the legs – place the table onto the floor facing the correct way up & then stand it
upright on one of the ends. Important – this should be carried out by 2 adults. If easier, turn
the table upside down onto the floor.
3. Fix the legs into the slots underneath the table using the bolts & nuts provided. Fit the rubber
feet to the bottom of each of the 4 legs.
Insert the coach bolts into the sides of the table followed by a nut. The square neck of the bolt
will not fit into the round hole. Tighten the nut so that the neck breaks into the laminate but
do not over-tighten – this will not cause the laminate to crack. The mushroom head of the bolt
should just touch the laminate surface.
To Next Page
Loading...