Note: The Red Plastic Plugs located in the “H” ports can stay in place fuel will not flow
through these ports. Coolant can be plumbed into these ports to heat the fuel in the Winter
months.
Note: O-Ring must be put back on suction side of pump.
Failure to do so can result in priming issues, cavitation, or
pressure loses.
To assist with priming your FASS pump crack the FF-3003. Put power to the FASS pump to
activate the pump. When the tone of the pump changes you can tighten up the fuel filter. If
you need a video of the priming process go to www.FASSride.com.
Step 5: Review Installation
Before starting installation please review contents page to insure all necessary parts are included. Please
call Diesel Performance Products for any missing or incorrect items. 636-433-5410
To Next Page
Loading...
