Fastbind Pureva XT - Hard Cover Paper Guide; Roughening Process; Applying Glue

FASTBIND PUREVA XT USER MANUAL | v 1.0 | © Maping Co 2014
17
DRAFT
HARD COVER PAPER GUIDE
• It can be used with both soft and hard covers
• When binding a soft cover book, align the cover
horizontally against the paper guide.
• When binding a hard cover book, pull the
spring loaded outer rim up and align the hard
cover against the inner rim. Release the outer
rim to lock the hard cover down.
Figure 10-x X
ROUGHENING
• For roughening the roughener back and forth
over the book spine when the table is in the
glueing position.
• The book spine must be roughened before
glueing.
• Compress the spine back to shape after
roughening to form a square shaped book
spine.
o
CAUTION!
▪
Do not use roughening after glue has
been applied to the book spine as glue
destroys the roughening parts!
APPLYING GLUE
• Glue is applied by moving heated hot glue
cartridge back and forth over the book spine
using applicator handle. The glue roller located
on bottom of the glue cartridge spreads the glue
on the book spine.
• Repeat to apply more glue to the spine. Avoid
applying too much glue.
o
WARNING!
▪
The applied glue is hot! DO NOT
TOUCH ANY HOT SURFACE AT ANY
TIME OR YOU RISK INJURY
▪
Do not touch the glue!
• Side gluing for soft cover books
o
Pull 3 to 4 times from the cover after
gluing to put more glue between the cover
andtherstpage.
• Side gluing for hard cover books
▪
Aftergluing,ipthespinestickonthe
glued book spine to get a professional
nish.
Figure 10-x X
Figure 10-x X