“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-200 Starogard Gdański tel,/fax:+48 58 56 300 80 www.ega.com.pl
l) The device must be properly maintained. Check for misalignment or fixing of moving parts,
broken parts and any other factors that may affect the operation of the power tool. The device
must be repaired before use if it is damaged. Many accidents are caused by poorly maintained
electrical tools.
m) The cutting tools must be sharp and clean. Properly maintained cutting tools with sharp cutting
edges are much less likely to get stuck in the work material and are easier to handle.
n) Use only accessories recommended for the model by the manufacturer. Accessories that are
specific to the one power tool may pose a risk when are used in the another device.
WARNING! The device is designed for indoor use. Despite of a safe structure from the very foundation
and use of protective measures and additional protective measures, there is always a risk of residual
injury during work.
5. Service
Service and repairs may only be performed by qualified technicians.
Corrective or maintenance actions performed by an unqualified person may contribute to the risk of
injuries.
When using the tool all safety guidelines should be abide in order to prevent injuries
and damages. On this account please read throughly manual instruction/safety
guidelines. Please keep the instruction and guidelines to any further use. In case of
transfering the device to another person, please give also the instruction
manual/safety guidelines. We are not responsible for accidents and damages
caused by non-compliance this manual and safety guidelines.
To Next Page
Loading...