24 VDC power, system (TB4)
Unregulated
Resettable and non-resettable
1.0 amp. max. each circuit, 1.0 amp. max. combined
Unsupervised
Battery Connection (TB7)
Supervised
24 VDC nominal
Max. battery size 31 AH
Non-power limited
0.6 A max. battery charge current
The RS-232 port, consists of an RJ11 connector which provides a standard serial port for connection to a
Listed output device for supplementary type service. Typical examples of such devices include any UL Listed
EDP device (remote printer or video terminal), any UL Listed Signaling Device (such as the Keltron VS4095/5
printer), or any UL Listed Signal System Unit (such as the Model BBM Buffered Data Broadcast unit TL160A-
R2).
Ratings: 15 VDC (max.)
.05 amp. (max.) current
9600 baud
8 bits, 1 stop bit, no parity.
Connections to the RJ11 serial connector are as follows:
Terminal Description
2 RXD
3, 4 GND
5 TXD
6 Supervision
Available cables for RS-232 connection are:
Part No. Model Description
6100-0077 RJ11-DB9PC RJ11 to 9-pin DB9
(Connector only - PC Laptop)
6100-0074 RJ11-DB25 RJ11 to 25-pin (DB25) (connector only-printer)
6100-0075 RJ11C-6 RJ11 to RJ11 cable, 6-inches
6100-0076 RJ11C-20 RJ11 to RJ11 cable, 20 feet
NOTE: The BSM is shipped with jumpers installed on the middle three pairs of pins on J2. These jumpers must
be removed when the PTRM is installed.
These jumpers must be removed prior to installing the PTRM
module.
BSM J2
1
2
3
4
5
6
RJ11 Connector
12 of 43 9000-0447
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...