keypad: enters password (shows as “XXX...” on display)
OK: if password is valid for desired level (or higher), opens
access, logs the event, and continues to next menu. If not,
returns to Main menu
keypad: enters new password for specified level and user
<>: scrolls through levels and users.
If current access level is lower than selection, password is
shown as XXXXXX, otherwise as digits.
<>: scrolls through available response categories: Alarm,
Manual Station, Supervisory, Tamper, or Waterflow. Note that
Alarm, Manual Station and Waterflow all produce alarm
response, except Manual Station may use PAS (depending on
the global PAS settings) and Waterflow disables silencing.
OK: accepts the response selection and opens the Edit Device
Type menu.
Initially, label comes up all underscores.
Keypad: enters text via telephone codes. Scrolls through the
numeral’s associated lower case letters, plus the numeral it-
self. Ex: press “2" key once for ‘a’, again for ‘b’, again for ‘c’,
and again for ‘2’. Another press scrolls back to ‘a’. To change
to/from upper case, press ”BKSP/EDIT". or scrolls to previous
or next letter. “BACK” exits to the Add Type menu without mak-
ing change. OK accepts new label and exits to the Select Input
Type menu.
Keypad: enters text (see Edit Device Type menu). OK: accepts
new text for selected address.
[CHANGE ] Level 1, User 1 111111
[PASSWORD] select key in password
Main
Config
Password
Error! Entry is not valid. Press BACK,
then change value or press BACK again.
[GAIN ] Type password for level 3:
[ACCESS] 000000
[DEFINE] AMM Type 43 (Alarm)
[TYPE ] 1: select response
Main
Config
Inputs
Type
Edit
(If BKSP/EDIT is pressed, and editing
is possible.)
Main
Config
Inputs (or Outputs)
Select
Location
Edit
———————— or ————————
Main
Config
System ID
Edit
Various
(If OK is pressed when illegal value
has been entered.)
Main
Any selection
(Only opens if adequate access has not
already been obtained)
Main
Config
Inputs
Type
Define Type
(After response category is accepted)
[EDIT ] Spark De(__ Alpha, repeat
[TYPE LBL] move, EDIT flip case, OK
[EDIT 1ST] (________ Alpha key, repeat
[LOC WORD] move, EDIT flip case, OK
26 of 43 9000-0447
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...