Main
I/O
Select
Output On/Off
1: Toggles Fire Drill ON/OFF.
2: Toggles Audible Walk Test ON/OFF.
3: Toggles Silent Walk Test ON/OFF.
1: Opens Select Device to Control menu.
2: Opens Select Device to Enable menu.
Note: These are the same menus as used in the Configure
section, or similar, except after selection they proceed to the follow-
ing menus.
1: Toggles selected output ON/AUTO.
Output selections include NAC1, NAC2, and Muni Circuit (if pre-
sent). These appear at the bottom of the output device scroll list,
and can be entered by keypad as addresses 0001, 0002, and
0003. (Note that AOMs start at address 1101.) If the selected
device is an AOM, its location is shown, otherwise NAC 1, NAC 2,
or Municipal Circuit. Status LEDs and relays are not considered
to be programmable outputs.
1: Toggles selected device ENABLED/DISABLED.
[Walk/] 1:Drill (OFF) 2:Audbl Test (OFF)
[DRILL] 3:Silent Test (OFF)
[CNTRL] NAC 1 (AUTO)
[L,AAA] 1:On/Auto
[ENA/DIS] Municipal Circuit (ENABLED)
[L,AAA ] 1:Enable/Disable
[I/O]1:OutputOn/Off
[CTRL] 2: Enable/Disable Device
Main
Walk/Drill
Main
I/O
Main
I/O
Select
Enable/Disable
9000-0447 35 of 43
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...