OPERATION ST80/ST80L Flow Meter
46 Fluid Components International LLC
Factory Reset
WARNING – The Factory Reset command reloads the con-
figuration and calibration parameters that were loaded into
the instrument during the original calibration and setup. Any
changes made to the calibration parameters configuration will
be lost when the Factory Reset command is executed.
ST80/ST80L Configuration
The configuration function eases the setup of the individual 4-
20 mA current output channels.
NOTE – Channel 3 setup applies to ST100A Series only.
ST80/ST80L Calibration Limits (Example)
The ST80/ST80L Calibration Limits function lets you review
the limits that have been set for the Flow and Temperature,
process parameters.
To Next Page
Loading...
