u) Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn
the fuel off at the conclusion of aerating or scarifying.
v) Danger – Do not touch the rotating tines
Maintenance and storage
a) Keep all nuts, bolts and screws tight to be sure the machine is in a safe working condition;
b) Never store the machine with petrol in the tank inside a building where fumes can reach an open flame or
spark;
c) Allow the engine to cool before storing in any enclosure;
d) to reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area free of
grass, thatch, moss, leaves or excessive grease;
e) Check the catcher frequently for wear or deterioration;
f) Examine the machine regularly and replace worn or damaged parts for safety;
g) If the fuel tank has to be drained, this should be done outdoors. The drained fuel should be stored in a
container specifically designed for fuel storage or it should be disposed of carefully.
Fuel Handling
Use caution when handling fuels. They are flammable and the vapors are explosive.
Use only an approved container.
Never remove the fuel cap or add fuel while the machine is on. Turn off the unit and allow the engine and
exhaust components to cool down before refueling.
Do not smoke.
Never refuel inside a room.
Never store the tool and the fuel tank indoors where there is a naked flame, such as near a water heater.
If fuel has spilled, do not attempt to start the machine, but move it away from the spill before starting to use it.
Please clean up any spills.
Replace and tighten the fuel tank cap after refueling.
Follow strictly the instructions in this manual for filling the tool with fuel.
During maintenance and storage
Switch off the tool and wait until it stops completely. Make sure that all moving parts are stopped.
Allow the machine to cool before performing inspection, adjustments, maintenance, servicing and storage.
Store the tool where fuel vapor will not reach a flame or spark.
The transport of the tool must be secured in order to avoid fuel spillage, accidents and injuries.
To Next Page
Loading...
