Fender Mustang GTX Series - Replacing an Effect; Effect Category Selection

To replace an eect, highlight the eect to be replaced in the SIGNAL PATH LAYER and press the ENCODER.
Select “REPLACE” from the menu of eects placement options and press the ENCODER again. Select one the four
eects categories that will appear—Stomp Box, Modulation, Delay or Reverb—and press the ENCODER to access
the eects in that category. Scroll through the eects and press the ENCODER to select one as a replacement.
The SIGNAL PATH LAYER will then display the new eect and indicate that the original eect has been replaced;
the box containing the preset number will change from blue to red (indicating that a preset edit has been
made), and the SAVE utility button will illuminate. With the eect now replaced, further edits can then be made
or the SAVE utility button can be pressed to keep completed edits (see illustrations below and on next page).
Note that pressing the PRESET LAYER button corresponding to the circled “X” in the DISPLAY WINDOW closes
the eects placement option and eects category menus; pressing it when it corresponds to the label “back”
(as on the eects menu) returns the user to the previous screen.
Turn the ENCODER to highlight “REPLACE” in eects placement options menu, then press the ENCODER to select it.
ROCK & ROLL
TWIN
REVERB
REVERBFUZZ
POST FX 1
To replace a highlighted eect, rst press the ENCODER to access the menu of eects placement options.
ADD FX
BYPASS
DELETE
MOVE
REPLACE
14
MODULATION
STOMPBOX
DELAY
REVERB
Turn the ENCODER to highlight one of four eects categories, then press ENCODER to select eects category.
TOUCH WAH
WAH
RANGER BOOST
OVERDRIVE
GREENBOX
back
Turn the ENCODER to highlight a replacement eect, then press ENCODER to select it.
REPLACING AN EFFECT