Fender Mustang GTX Series - Editing Effects Settings; Adjusting Individual Effect Parameters

In the second method of adding an eect, highlight an existing eect in the SIGNAL PATH LAYER and press
the ENCODER. Select “ADD FX” from the menu of eects placement options and press the ENCODER again.
Select one the four eects categories that will appear and press the ENCODER to access the eects in that
category. Scroll through the eects and press the ENCODER to select an eect.
The SIGNAL PATH LAYER will then display the newly added eect in a green box with a blinking white arrow
below it and a label above it, indicating that the eect can be moved to a dierent position (if preferred) by
turning and then pressing the ENCODER.
When an eect is added, the box containing the preset number will change from blue to red (indicating that a
preset edit has been made), and the SAVE utility button will illuminate. With the eect now added, further ed-
its can then be made or the SAVE utility button can be pressed to keep completed edits (see illustrations below
and on next page).
18
ROCK & ROLL
TWIN
REVERB
REVERBFUZZ
POST FX 1
LEVEL DECAY
DWELL DIFF TONE
In another way to add an eect, highlight an existing eect within a preset by turning the
ENCODER to it and pressing the ENCODER to see a menu of four eects categories.
ADD FX
BYPASS
DELETE
MOVE
REPLACE
Select “ADD FX” in the eects placement options menu by scrolling to it and pressing the ENCODER.
MODULATION
STOMPBOX
DELAY
REVERB
Select an eects category by scrolling to it and pressing the ENCODER.
TOUCH WAH
WAH
COMPRESSOR
SIMPLE COMP
RANGER BOOST
back
Select an eect by scrolling to it and pressing the ENCODER.