Need help?Do you have a question about the Fender VIBRO-KING P/N 053493 and is the answer not in the manual?
Power| power requirements (100V) | 100V AC, 50/60 Hz 195W |
|---|---|
| power requirements (120V) | 120V AC, 60 Hz, 195W |
| power requirements (230V) | 230V AC, 50 Hz, 195W |
| power requirements (240V) | 240V AC, 50 Hz, 195W |
Power Output and Impedance| power output | 60W into 2Ω |
|---|---|
| input impedance (input 1) | 1 MΩ |
| input impedance (input 2) | 136 kΩ |
Tubes and Fuses| tubes (12AX7A) | Four (4) |
|---|---|
| tubes (5881/6L6) | Two (2) |
| tubes (6V6) | One (1) |
| fuse (100V and 120V) | 3A 250V |
| fuse (230V and 240V) | 1.6A 250V |
Speakers| speaker type | Reissue “Blue Frame” |
|---|---|
| speaker size | 10 inches |
| speaker impedance | 8Ω |
| number of speakers | Three (3) |
Weight and Dimensions| height | 25.5 in / 64.8 cm |
|---|---|
| width | 24.75 in / 62.9 cm |
| depth | 10.5 in / 26.7 cm |
| weight | 72 lbs / 32.7 kg |
Introduces the Fender Vibro-King Professional Tube Amplifier, highlighting its construction and features.
Primary input for connecting your guitar.
Secondary input with lower impedance, useful for active pickups or chaining amps.
Adjusts the amount of reverb sustain, affecting the character of the reverb effect.
Controls the wet/dry ratio of the reverb, balancing the reverb signal with the dry signal.
Adjusts the tonal characteristics of the reverb, affecting its brightness or darkness.
Boosts preamp gain for an overdriven or 'fatter' sound at lower volumes.
Adjusts the overall output volume of the amplifier.
Adjusts the level of high frequencies, influencing the amplifier's tone and overdrive characteristics.
Adjusts the level of low frequencies, impacting the amplifier's overall tonal balance.
Adjusts the level of mid-frequencies, shaping the core tone of the amplifier.
Adjusts the speed of the Vibrato feature, controlling the oscillation rate.
Adjusts the intensity of the Vibrato feature's signal modulation.
Indicator light showing when the amplifier is receiving power.
Grounding type supply cord to reduce shock hazard; connect to a grounded AC receptacle.
Protects the amplifier from electrical faults or tube failure; replace with identical type/rating.
Turns the main AC power ON and OFF.
Allows the amplifier to be ready for performance or to conserve tube life during breaks.
Primary connection for the internal speakers.
Connects an external speaker enclosure in parallel with the main speaker jack.
Connects the footswitch for remote control of Fat and Vibrato features.
Input jack for connecting external processing devices like delays or chorus units.
Output jack for sending signal to external processing devices.
Guide to replacing vacuum tubes, emphasizing safety and correct procedure.
A list of common issues and checks to perform if the amplifier does not function correctly.
Instructions for cleaning and maintaining the amplifier's Tolex covering.
Details on type, part number, power requirements, output, impedance, tubes, fuse, speaker, and footswitch.
Physical dimensions (height, width, depth) and weight of the amplifier.
Safety warnings regarding fire/shock hazard, moisture, user-serviceable parts, and grounding.
To Next Page