FENDT 8380 P - Engine type plate; Cutting table type plate

FENDT 8380 P - 8410 P - EAME 19
D3157100M2 - S/N 582000001 - 582400000 - 583000001 - 583400001
1
1. General Information
Crop_this_page
Placement of type and number plates
The type description and serial number of the com-
bine are displayed on the plate and are also
stamped on the back of the main frame on the right-
hand side (1).
Engine type plate
The engine can be identified by an information plate
(1) (circled) located at the centre of the engine
block.
The plate (1) displays the following information:
– Engine manufacturer
– Engine type
– Engine power and rated rpm
– Engine serial number
– Valve clearance
– Customer code
– Idle speed
– Accordance with Machinery Directive 97/68/EC
– Engine technician name
– The engine serial number is always stamped on
the cylinder block.
Cutting table type plate
The cutting table can be identified by a CE type
plate (1) on the right-hand side.
NOTE: This picture shows PF35.
I048870
Fig. 2.
I048807
Fig. 3.
I048820
Fig. 4.