EasyManua.ls Logo

FENDT 938 Vario MT - Coolant Quality Requirements; Fuel Quality Requirements

FENDT 938 Vario MT
51 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Thread Strength class
8.8 10.9 12.9
M8 25 Nm 35 Nm 40 Nm
M10 50 Nm 75 Nm 85 Nm
M12 85 Nm 125 Nm 145 Nm
M14 135 Nm 200 Nm 235 Nm
M16 210 Nm 310 Nm 365 Nm
Use a washer with the aluminum parts.
1
.6.10.3 Coolant quality requirements
AGCO Power Inc. recommends to use coolants that follow in all AGCO POWER engines:
Arteco, Havoline XLC
BASF, Glysantin G30
In addition, coolants under other brand names, which can be proved to use exactly the same inhibitor
package as Arteco Havoline XLC or BASF Glysantin G30, are recommended to be used.
If Arteco Havoline XLC, BASF Glysantin G30 or coolant which uses the same inhibitor package is used, the
coolant change interval can be extended from two years up to five years. If any other coolant is used, the
coolant change interval is two years.
Requirements
The coolant used must meet the demands of
standard ASTM D 3306 or BS 6580:1992.
The cooling mixture must consist 40 - 60 % of
ethylene/propylene-glycol based antifreeze and
water. The best proportion is 50 % of antifreeze
liquid and 50 % of water.
The water used must be mechanically clean
and not too acid (e.g. swamp water) or too hard
(calciferous well water).
Check periodically the proportion of antifreeze
(the frost resistance) in the coolant.
Do not mix ethylene- and propylene-glycol
based antifreeze.
Change the coolant every two years.
NOTE:
Use only coolant that is a mixture of 40-60% water
and antifreeze. Refer to the engine specification
for the machine, for the specified ratio and the
quantities necessary. Do not use water only for the
coolant.
GUID-EE6ADAB9-3ECA-4D47-9484-6E50DF166BAC-high.eps [High]
Fig. 35
DANGER: Antifreeze is dangerous to health.
Injury t
o persons.
Do not let antifreeze touch the eyes and skin.
1.6.10.4 Fuel quality requirements
The use of fuels that are not permitted can cause faults in the engine and the exhaust gas aftertreatment
system. These faults can cause:
GUID-5C9A453D-3B9B-4DD7-A6D0-BE179CA6E967 [V3]
GUID-61202AC9-CDDD-41EF-A705-ED13236ADD21 [V11]
1. General
1-38 R
ubber Track Tractor
79037495A

Table of Contents

Related product manuals