FENDT Vario 716 - Connect to Existing Chassis Cable

Chapter 4
24 Fendt Vario 700, 800, and 900 Series SmarTrax™ MD Installation Manual
Connect SmarTrax MD to an Existing
Chassis Cable (If Applicable)
Note: The SmarTrax MD interface tee is sold separately. Contact your local Raven dealer for ordering
information.
1. Locate and disconnect the connection between the Raven console cable and chassis cable on the
machine’s existing CAN system.
2. Install the SmarTrax MD interface tee cable (P/N 115-4001-070 or 115-4001-071) between the chassis and
Raven console harness.
3. Connect the SmarTrax node harness (P/N 115-4001-157) to the remaining SmarTrax MD interface tee.