FENDT Vario 724 - Page 16

Chapter 3
12 Fendt Vario 700, 800, and 900 Series SmarTrax™ MD Installation Manual
FIGURE 7. Anti-Rotation Bracket Installed
4. Clamp the collar weldment bracket (P/N 116-0159-751) around the steering column and secure it using the
machine’s bolts that were removed in step 2.
FIGURE 8. Flanged Bearing Installed on Bracket
5. Install the 1/2” plastic flanged bearing (P/N 325-0000-036) on the end of the collar weldment bracket using
two #10-24 x 3/4” carriage bolts (P/N 311-0069-082) and two #10-24 wing nuts (P/N 312-3000-013).
Collar Weldment
Bracket
(P/N 116-0159-738)
#10-24 x 3/4” UNC
Carriage Bolts
(P/N 311-0069-082)
1/2” Plastic
Flanged Bearing
(P/N 325-0000-036)
#10-24 Wing Nuts
(P/N 312-3000-013)