Step 1
Remove the grate, clean
the internal surface of the
pipe and fold the drain
seal as shown above.
Step 2
Insert the drain seal into
the pipe. (There is no need
to place the seal too far
down the pipe.)
Step 3
Smooth out the fold ush to
the internal surface of the
pipe ensuring parallel t to
the pipe completing the seal.
Installation Steps
Tel: 03 8369 9500 | Email: sales@hydroowaus.com.au
Distributed by
Prevent odours
Fernco Drain Seal is specically designed to
prevent odours entering properties/buildings
from drains. The EPDM rubber valve, which
can be simply retro tted into a riser pipe,
acts as a one way valve allowing waste water
to exit the building whilst blocking the return
of odours, soapy suds, insects etc.
www.hydroowaus.com.au
To Previous Page
Loading...