LED BARS & POWER ADAPTER
8
GB Preliminary warnings
• Ensure that the voltage shown on the all electrical components corresponds
to that of your home electrical power supply.
• The aquarium is intended only for indoor use.
• Before switching on make sure your home is protected by an automatic
safety breaker switch (or individual breaker plug) with an operating current
of no more than 30 mA.
• Always disconnect all appliances from the electric power supply before
carrying out any maintenance.
• The tubes and the overtank lamp must never be submerged.
• The power supply cable can not be repaired or replaced: if damaged, the
whole appliance must be replaced.
• The LED Bar does not include the power adapter, which must be purchased
separately. The LED Bar must be used only with Ferplast power adapter.
• Ferplast power adapter must be used only with Ferplast Led Bars.
• The connectors between the bar and the power adapter must be correctly
xed with the ferrule completely tightened in order to ensure water
protection (IP67).
Led bar
Power
adapter
!
67012000-17-000#FI_LED_BARS.indd 8 19/01/17 13:50
To Next Page
Loading...