MT Owners Manual
3.2 Safety Rules Concerning the Hydraulic System:
• This shredder uses a hydraulic circuit to operate the shifting of the 3 point
linkage; the pressure of such system must not exceed 170 BAR.
• Label the different pipes to avoid reversal of operation.
IMPORTANT: Do not look for oil leaks with bare hands, but always with the aid of gloves
or a cloth. Oil under strong pressure may seep into the skin causing serious
infections. If this happens contact a doctor immediately.
• Periodically check the flexible pipes, if they are worn or damaged they must be
replaced with new pipes with the same specifications.
• Before working on the hydraulic system, lower the machine, release the pressure
out and bleed the presure, then stop the tractor.
3.3 Safety Rules Concerning Road Traffic:
• While in transport reduce speed, especially on bumpy roads. The weight of the
lifted shredder may render driving difficult and damage the shredder itself.
• Check that the hydraulic lift levers are locked to avoid the lowering of the
machine during transport.
• When driving on public roads, respect all road rules in force.
3.4 List of Guards attached to the shredder (Figure 13):
1 - Front Guard
2 - PTO Shaft Bearing
3 - PTO Shaft
4 - Belt Guard
5 - Belt Guard
6 - Danger and Warning Decals
7 - Rear Guard
Figure 13
10
To Next Page
Loading...