FERRI MT Series - Page 19

MT Owners Manual
Assembling the mobile linkage (front and reverse version, Figure 29).
• Fix the holder to the frame (1) with screws (2), assemble the 3 point linkage (3) to
the holder with the tube (4) and fix it with screws (5). Assemble the holder (6) with
the tie rod (8) and fix with screws (9).
• Fix the guard (10) to protect from the possible throwing of objects by the shredder,
always remembering to make the necessary holes while assembling the guard.
NOTE: The guard can be assembled in the position A, in case of discharge of
material opposite the roller (roller in backward position); or also assebled in position
B is available, in case of discharge of material behind the roller (roller in forward
position).
IMPORTANT: When using a front version shredder, the PTO shaft with free wheel
must have the rotational direction opposite to that of the rear or reverse version.
Assembling the rod for the manual mobile linkage (Figure 30)
Insert the rod (1) from the threaded side into the hole of the square (2) and fix it with
the bolt (3). Insert the pin (4) into the hole of the rod corresponding to the desired
movement and fix with the spring clip (5).
Figure 29
Figure 30
17