How to fix black exhaust from Ferris Blower?
If the engine exhaust of your Ferris Blower is black, it could be due to a dirty air filter or the engine choke control lever being in the closed position. Try replacing the air filter. Also, move the choke control lever to the open position.
What to do if my Ferris 5901810 Blower engine starts hard?
If your Ferris Blower engine starts hard or runs poorly, the fuel mixture might be too rich, the spark plug(s) might be faulty, fouled, or incorrectly gapped or the fuel filter might be plugged. You can try cleaning the air filter and checking the choke adjustment. Also, replace the fuel filter.
Why does my Ferris 5901810 engine run but the unit won't drive?
If your Ferris Blower engine runs but the unit won't drive, it could be due to the hydraulic pump bypass valve(s) being in the bypass position. Move the hydraulic bypass valve(s) to the run position.
Why is my Ferris Blower using too much oil?
Excessive oil consumption in your Ferris Blower could be caused by the engine running too hot or using the wrong weight engine oil, or too much oil in the crankcase. You can clean the engine fins, blower screen, and air cleaner. Also, drain excess oil.
Why is my Ferris 5901810 Blower engine knocking?
If your Ferris Blower engine is knocking, it could be due to a low oil level. Check and add oil as required.
What to do if my Ferris 5901810 Blower engine will not start?
If your Ferris Blower engine won't start or is hard to start, several factors could be the cause. Here's what to check: * Ensure the park brake lever is engaged. * Confirm that the motion control levers are in the NEUTRAL position. * Refill with fresh fuel if the fuel is stale, low, or improper. * Replace the fuel filter if it's plugged. * Replace the air intake filter if it's plugged. * Reconnect any loose or disconnected spark plug wires. * Correctly gap the spark plugs. * Replace any blown fuses. * Replace or charge a dead battery. * Adjust the choke if it's applied incorrectly.
Why does my Ferris 5901810 Blower engine run rough or stall?
If your Ferris Blower engine runs roughly or stalls, consider these potential causes and solutions: * Replace the fuel filter if it's plugged. * Clean the air intake system if it's plugged. * Clean the fuel cap vent if it's dirty. * Refill with fresh fuel if the fuel is stale or improper, or if the fuel level is low. * Gap the spark plugs correctly if they are not gapped correctly. * Adjust the choke if it's applied incorrectly.
What causes the engine to knock on my Ferris 5901810?
If your Ferris Blower engine is knocking, here's what you should check: * Fill the engine with oil if the engine oil level is low. * Fill the tank with fresh fuel if the fuel is bad. * Increase engine RPMs if the idle speed is too slow.
What to do if my Ferris Blower engine will not slow idle?
If your Ferris Blower engine won't slow to idle, it could be due to several reasons: * Replace the throttle cable if it's bent or kinked. * Replace the governor control if it's bent. * Adjust the governor idle control if it's incorrect.
Why won't my Ferris 5901810 engine start?
Your Ferris Blower engine might not start due to several reasons: the parking brake might not be engaged, the unit might be out of fuel, the engine could be flooded, there might be a blown fuse, the battery terminals could be dirty, the battery could be discharged or dead, the wiring might be loose or broken, the safety interlock switch could be faulty, the spark plug(s) could be faulty, fouled, or incorrectly gapped, there could be water in the fuel, or the gas could be old or stale. To address these issues: * Engage the parking brake. * If the engine is hot, allow it to cool, then add fuel to the fuel tank. * Move the choke control lever to the closed position. * Replace the fuse. * Clean the battery terminals. * Charge or replace the battery. * Visually check the wiring a...
To Next Page
General