EasyManua.ls Logo

Ferris IS2600Z Series - Page 12

Ferris IS2600Z Series
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Not for
Reproduction
12 ferrismowers.com
Danger - Tipping and slipping
hazard: Operating on slopes can
be hazardous and cause a loss
of control and roll-overs. Do not
operate on slopes over 15* degrees.
Avoid sudden turns or rapid speed
changes. Reduce speed and use
extreme caution on slopes. Avoid
turning down slopes; if possible,
turn up slopes. Do not operate
down slopes towards or near water,
retaining walls, or drop-offs. Give
yourself a minimum of two mower
widths of clearance around these
hazards.
Danger - Thrown objects hazard:
Keep bystanders and children a
safe distance away. Remove objects
that can be thrown by the blade. Do
not mow without discharge chute in
place.
*This limit was determined per International Standard ISO 5395-3:2013,
Section 4.6 and is based on the ISO 5395-3 Stability Test procedure
described in Annex A. The 15 degree “limit of stability” is equal to 60%
of the angle at which machine lift-off occurred in static tests. Actual
dynamic stability may vary depending on operating conditions.
7106109 - Decal, Danger, Discharge
Danger - Thrown Objects Hazard:
Do not mow without discharge chute or
entire grass catcher in place.
Danger - Amputation and Thrown
Objects Hazard: To avoid injury from
rotating blades, stay clear of deck edge
and keep others away.
5102456 - Decal, Fire
Danger: Fire Hazard: Keep unit free of
grass, leaves and excess oil. Do not add fuel
while engine is hot or running. Stop engine,
remove key and allow to cool for at least 3
minutes prior to adding fuel. Do not add fuel
indoors, in an enclosed trailer, garage or
other enclosed areas. Clean up spilled fuel.
Do not smoke while operating this machine.
5102000 - Decal, Warning, Hot
Warning: Escaping Steam
Can Cause Burns - Never
remove the radiator cap or
radiator reservoir cap while
the engine is hot or running.
Severe thermal burns or
injury can occur by escaping
steam or hot coolant.
5061246 - Decal, Pinch Point
Danger: Dismemberment - This machine
can crush and cut. Keep hands away from
deck lift rod.
5101353 - Decal, Warning, Hot Surface
Warning: Hot Surface - Avoid contact with
engine and hot surfaces. Wait for unit to
cool before touching.
5061042 - Decal, Danger

Related product manuals