Ferroli BLUEHELIX TECH RRT 24 H Instruction For Use, Installation And Assembly

BLUEHELIX TECH RRT 24 H
189EN
cod. 3541C662 - Rev. 00 - 09/2020
Opening the front panel
B
Some internal components of the boiler can reach temperatures high
enough to cause severe burns.Before carrying out any operation, wait for
these components to cool or else wear suitable gloves.
To open the boiler casing:
1. Partially undo the screws A (see fig. 34).
2. Pull the panel B towards you and release it from the upper fastenings.
fig. 34- Front panel opening
B
On this unit, the casing also acts as a sealed chamber. After any operation
involving opening the boiler, carefully check the correct refitting of the front
panel and its seal.
Proceed in reverse order to refit the front panel. Make sure it is correctly hooked to the upper fastenings and is correctly
positioned at the sides. When tightened, the head of screw "A" must not be below the lower fold (see fig. 35).
fig. 35 - Correct position of front panel
A
A
B
A
OK NO

Ferroli BLUEHELIX TECH RRT 24 H Specifications

General

Brand	Ferroli
Model	BLUEHELIX TECH RRT 24 H
Category	Heater
Language	English