8
Required items: 4 cable ties
Connect the large tail fin to the rudder horns of the servo motor using 2 cable ties. Pull
the cable ties through the two small tabs of the fin and then through the openings of the
rudder horn in a crisscross fashion. The two cable ties cross above the fin. Add 2 more
cable ties to act as stopper.
Testing
Carefully move the rudder horn back and forth with your finger to check the tension of the
cable ties. If the fin does not move evenly, the length or the tension of the cable ties may
have to be corrected.
To Next Page
Loading...
