Festo CMMS-AS-C4-3A-G2 Assembly And Installation

B Diagnostic messages
68 Festo – GDCP-CMMS-AS-G2-HW-EN – 1310NH – English
Diagnostic messages
Code ReactionMessageNo.
7584h 64-1 DeviceNet general error PS off
65-0 DeviceNet general error Configurable
7680h 29-0 No SD Configurable
7681h 29-1 SD initialisation Configurable
7682h 29-2 SD parameter set Configurable
8000h 45-0 Driver supply error PS off
45-1 Driver supply error PS off
45-2 Driver supply error PS off
05-2 Driver supply error PS off
8087h 45-3 DIN4 plausibility error PS off
8130h 12-4 CAN: time-out node guarding Configurable
8181h 12-0 CAN: general error Configurable
12-1 CAN: error bus off Configurable
12-2 CAN: error sending Configurable
12-3 CAN: error receiving Configurable
12-5 CAN: error in IPO mode Configurable
8600h 42-4 Homing required message Configurable
8611h 17-0 Following error monitoring Configurable
8612h 40-0 Negative software limit switch reached Configurable
40-1 Positive software limit switch reached Configurable
40-2 Target position lies behind the negative software limit switch Configurable
40-3 Target position lies behind the positive software limit switch Configurable
43-0 Negative limit switch error Configurable
43-1 Positive limit switch error Configurable
43-9 Fault in limit switch Configurable
8681h 42-1 Position precomputation Configurable
8A81h 11-1 Homing error PS off

Festo CMMS-AS-C4-3A-G2 Specifications

General

Brand	Festo
Model	CMMS-AS-C4-3A-G2
Category	Controller
Language	English