6. Electrical installation
90 Festo P.BE-CMMS-AS-HW-EN en 0708NH
6.3 Entire CMMS-AS system
A complete CMMS-AS motor controller system is shown in 220HFehler! Verweisquelle konnte
nicht gefunden werden.. To operate the motor controller, the following components are
needed:
- 24V power pack for control voltage supply (see Chap-
ter A.3.1)
- Power supply (see Chapter A.3.1)
- Motor controller CMMS-AS
- Motor EMMS-AS
- Cable set consisting of motor and encoder line NEBM-
A PC with a serial connection cable is required for parameterizing.
To Next Page
Loading...
Need help?
General
