1. General remarks
Festo P.BE-CMMS-CO-SW-EN 1012a 9
Warning
Faults in the parametrisation can cause injury to human beings and
damage to property.
Enable the controller only if the axis system has been correctly
installed and parametrised.
1.3 Target group
This manual is intended exclusively for technicians trained in control and automation
technology, who have experience in installing, commissioning, programming and
diagnosing positioning systems.
1.4 Service
Please consult your local Festo Service or write to the following e-mail address if you have
any technical problems:
service_international@festo.com
1.5 Important user instructions
Danger categories
This description contains instructions on the possible dangers which can occur if the
product is not used correctly. These instructions are marked (Warning, Caution, etc),
printed on a shaded background and marked additionally with a pictogram.
A distinction is made between the following danger warnings:
Warning
... Means that failure to observe this instruction may result in
serious personal injury or damage to property.
Caution
... Means that failure to observe this instruction may result in
personal injury or damage to property.
Note
... Means that failure to observe this instruction may result in
damage to property.
To Next Page
Loading...
Need help?
General
