Festo CPX-CMAX-C1-1 User Manual

5. Parameter
5−64
Festo P.BE−CPX−CMAX−CONTROL−EN en 0908NH
Direct mode position tolerance
PNU PNU: 545 Index: 1 Max index: 1 Class: Var Data type: int32
Values Unit: Position (index = 1)
Linear drive Semi−rotary drive
Dimension Default Minimum Maximum Dimension Default Minimum Maximum
SI 0.01 mm 100 10 1.000 0,1 ° 10 1 100
Imperial 0.001 in 40 4 394 0,1 ° 10 1 100
Tolerance in position control direct mode.
Depending on PNU 521:02, the corresponding default value is used instead, if necessary.
o The parameter value cannot be changed.
o Writing permissible only in commissioning/parametrising mode with disabled controller.
o This parameter can be written by FCT without higher−order controller.
o After writing, controller recalculation is carried out.

Festo CPX-CMAX-C1-1 Specifications

General

Brand	Festo
Model	CPX-CMAX-C1-1
Category	Controller
Language	English