5
19 Store idle tools out of reach of children
and other untrained persons. Tools are
dangerous in the hands of untrained users.
20 Maintain tools with care. Keep cutting
tools sharp and clean. Properly maintained
tools, with sharp cutting edges are less likely to
bind and are easier to control.
21 Check for misalignment or binding of
moving parts, breakage of parts, and any
other condition that may affect the tools
operation. If damaged, have the tool
serviced before using. Many accidents are
caused by poorly maintained tools.
22 Use only accessories that are
recommended by the manufacturer for
your model. Accessories that may be suitable
for one tool, may become hazardous when used
on another tool.
Service
23 Tool service must be performed only by
qualified repair personnel. Service or
maintenance performed by unqualified personnel
could result in a risk of injury.
24 When servicing a tool, use only
identical replacement parts. Follow
instructions in the Maintenance section of
this manual. Use of unauthorised parts or
failure to follow Maintenance instructions may
create a risk of electric shock or injury.
1 Symbols
V volts
A amperes
Hz hertz
W watt
alternating current
n
0
no load speed
Class II Construction
rpm revolutions per minute
spm strokes per minute
2 Functional description
2.1 Use for intended purpose
The sanders are designed for sanding wood,
plastic, composite materials, paint / varnish,
filling material and similar materials.
Metal and materials with an asbestos content
must not be processed with these tools.
The machines must not be damp nor operated
in a damp environment for electrical safety
reasons. The machines may only be used for
dry sanding.
The user is liable for damage and injury resulting
from incorrect usage!
2.2 Electrical connection and operation
The mains voltage must correspond with the
voltage on the rating plate!
Technical data ES 150/3 EQ ES 150/5 EQ
Wattage W 310 310
No load speed rpm 4 000 - 10 500 4 000 - 9 500
No. of strokes spm 8 000 - 21 000 8 000 - 19 000
Sanding stroke mm 3.0 5.0
Sanding base Æ mm 150 150
Weight kg 1.8 1.8
Safety level UL 745, CSA C22.2 No. 745
The specified illustrations can be found at the beginning of the operating instructions.
Always switch the machine off
before connecting or disconnecting the power
cable!
See Fig. 3 for connection and disconnection of
the power cable.
Switch (1.2) is an on/off switch. For continuous
use it can be engaged with the lateral locking
button (1.3). Pressing the switch again releases
the lock.
3 Machine settings
Always disconnect the plug from
the power supply before making any
adjustments to the machine or installing or
removing any accessory!
3.1 Electronic control
The ES 150/3 EQ, ES 150/5 EQ has an electronic
control with which the rotational speed can be
varied step-free. This allows the sanding speed
to be adapted to the optimum level according
to the material concerned.
The speed is set using the rotary control button
(1.1). The numbers on the rotary control button
represent approximately the following strokes
per min:
To Next Page
Loading...
