Festool ETS EC 150/3 EQ - Working with the Machine

4UJDL'JY
#
8.5 Dust extraction
WARNING
Hazardous dust
Damage to the respiratory passage
► Always work with an extractor.
► Comply with national regulations.
► Wear a dust mask.
A Festool mobile dust extractor with an extrac
tion hose diameter of 1‑1/16" (27 mm) should
be connected at the extractor connector [1-5].
Recommendation:
Use an antistatic extractor
hose. This helps reduce the electric charge.
9 Working with the machine
WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move.
Observe the following information:
– Do not overload the machine by applying
too much pressure. The best sanding re
sults are achieved with moderate applica
tion pressure. The sanding performance
and quality depend mainly on selecting the
correct abrasive.
– Hold the machine with two hands – one on
the motor housing and one on the gear
head [1-6] – to ensure safe guidance.
For sanding, we recommend the following set
tings for the adjusting wheel [1-2]:
Sanding work Adjusting wheel
setting
– Sanding with max. abrasion
– Sanding off old paint
– Sanding of wood and veneered sur
face prior to paintwork
– Intermediate sanding of paintwork
on surfaces
5–6
– Sanding thinly applied undercoat
– Sanding wood with sanding cloth
– Edge breaking on wooden parts
– Smoothing primed wooden surfa
ces
4–5
– Sanding solid wood and veneered
edges
– Sanding rebate of windows and
doors
– Intermediate sanding of paintwork
at edges
– Light sanding of natural wood win
dows using sanding cloth
– Smoothing wooden surfaces using
sanding cloth before staining
– Rubbing stained surfaces with a
sanding cloth
– Rubbing or removing excess lime
stone residue using sanding cloth
3–4
– Intermediate sanding of paintwork
on stained surfaces
– Cleaning natural wood window re
bate using sanding cloth
2–3
– Sanding stained edges
– Sanding thermoplastics
1–2
9.1 Extension Cord
If an extension cord is required, it must have
sufficient cross-section to prevent an excessive
drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table below shows
you the correct cord diameter as a function of
the cord length for this tool.
Cord Size in A.W.G
Tool`s Ampere Rating Cord Length in Feet
25 50 100 150
3-6 18 16 16 14
6-8 18 16 14 12
English
8