– Use an aluminium saw blade.
Wear protective goggles.
2.6 Emission levels
The levels determined in accordance with
EN 60745 are typically:
Sound pressure level L
PA
= 91 dB(A)
Sound power level L
WA
= 100 dB(A)
Uncertainty K = 3 dB
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
The specified noise emission values
– have been measured in accordance with a
standardised test procedure, can be used
to compare one power tool with another,
– and can also be used for a provisional as
sessment of the load.
CAUTION
Depending on how the power tool is used,
particularly which type of workpiece is being
machined, the noise emitted by the power
tool during use may deviate from the speci
fied values.
► To protect the operator, safety measures
should be defined based on load estimates
obtained under real conditions of use. (All
parts of the operating cycle must be taken
into account here, including, for example,
times in which the power tool is switched
off or when it is switched on but idling.)
3 Intended use
The power tool is a stationary unit designed for
sawing blocks of wood, plastic, aluminium pro
files and similar materials. Do not use it to
process other materials, in particular steel,
concrete and mineral materials.
Only use Festool saw blades that are designed
for use in this power tool.
The saw blades must comply with the following
data:
– Saw blade diameter 216 mm
– Cutting width 2.3 mm (corresponds to the
tooth width)
– Locating bore 30 mm
– Standard blade thickness1.6 mm
– Saw blade in accordance with EN 847-1
– Saw blade with chip angle ≤ 0°
– Suitable for speeds above 5000 rpm
Festool saw blades comply with EN 847-1.
Only saw materials for which the saw blade in
question has been designed.
This power tool may only be used by experts or
instructed persons.
The user is liable for damage and acci
dents caused by improper and non-inten
ded use.
4 Technical data
Sliding compound mitre
saw
KS 60
Power 1200 W
Power supply 220–240 V~ 50–60
Hz
Speed (no-load)
1300–3500 rpm
Max. speed
[2]
5000 rpm
Max. mitre angle 60° left/right
Max. inclination angle 47/46° left/right
Saw blade dimensions 216 x 2.3 x 30 mm
Weight as per EPTA-
Procedure 01:2014
17.8 kg
5 Machine features
[1-1]
Handle
[1-2]
Safety button
[1-3]
On/Off switch
[1-4]
Lever for groove depth limit
[1-5]
Rotary knob for slide locking device
[1-6]
Lever for transport locking device
Spindle stop
[1-8]
Stop ruler (both sides)
[1-9]
Rotary knobs for securing the table
extension (both sides)
[1-10]
Angle display for mitre cuts
[2] Max. speed in the event of faulty electronics.
English
30
To Next Page
Loading...
