Transferring the angle [15]
► Place the angle bevel perfectly in place on
one of the stop rulers .- press with your
thumb.
► Release the rotary knob
.
► Hook in the detent lever
.
► Swivel the rotary base
, until the out
side edge of the bevel is congruent with the
marking
.
To do so, the bevel must be positioned so
that it is parallel to the stop of the com
pound mitre saw. At the same time, apply
pressure to the stop ruler by pressing in
the recessed grip with your thumb.
► Close the rotary knob
, remove the an
gle bevel.
The angle is transferred, the sawing process
can be started.
10.2 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli
cations and these are specially designed for
your Festool saw.
11 Environment
Do not dispose of the device in the
household waste! Recycle devices, ac
cessories and packaging. Observe appli
cable national regulations.
EU only: In accordance with the European Di
rective on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
and handed in for environmentally friendly re
cycling.
Information on REACH: www.festool.com/reach
12 Contact us
경기도 의왕시 맑은내길 67, 501-2호
(오전동, 에이엘티지식산업센터)
(우) 16071
전화: 02-6022-6740
팩스: 02-6022-6799
http://www.festool.co.kr
ALT Center A 5F, Malgeunnae-gil 67
Uiwang-si, Gyeonggi-do
16071
phone: 02-6022-6740
fax: 02-6022-6799
http://www.festool.co.kr
English
38
To Previous Page
Loading...
