13
OF 1010
b. Only use the correct batteries in the power
tools. The use of different batteries may lead
to injury and a risk of fire.
c. When the battery is not in use, keep it away
from paper clips, coins, keys, nails, screws and
other small metal objects which could bridge
the contacts. A short circuit between the bat-
tery contacts may pose a risk of burns or fire.
d. Fluid may leak out of the battery if it is used
incorrectly. Avoid contact with the fluid. Rinse
with water any areas which accidentally come
into contact with the fluid. If fluid gets into the
eyes, also consult a doctor. Leaking battery
fluid can cause skin irritation or burns.
e. Do not use damaged or modified batteries.
Batteries which are damaged or which have
been modified may behave unpredictably, which
could lead to fire, explosion or the risk of injury.
f. Do not expose a battery to fire or excessive
temperatures. Fire or temperatures exceeding
130 °C may cause an explosion.
g. Follow all instructions on charging and never
charge the battery or the cordless tool outside
the temperature range stated in the operating
instructions. Incorrect charging or charging
outside the permitted temperature range can
destroy the battery and increase the risk of fire.
6 SERVICE
a. Only ever have your power tool repaired by
qualified specialist staff and always use origi-
nal spare parts. This ensures that the safety of
the power tool is maintained.
b. Never perform maintenance on damaged bat-
teries. Maintenance on batteries should only
ever be performed by the manufacturer or
authorised customer service centres.
c. Only use original parts for repairs and main-
tenance. The use of incompatible accessories
or spare parts can result in electric shocks or
other injuries.
2.2 Tool-specific safety rules
- Hold power tool by insulated gripping surfaces,
because the cutter may contact its own cord.
Cutting a „live“ wire may make exposed metal
parts of the power tool “”live”” and could give
the operator an electric shock.
- Use clamps or another practical way to secure
and support the workpiece to a stable platform.
Holding the work by your hand or against the
body leaves it unstable and may lead to loss of
control.
- Do not exceed the maximum speed specified on
the tool and/or keep to the speed range.
- The clamping collet should only be used to
clamp tools with a shank diameter appropriate
for the collet.
- Check that the cutter is firmly fitted and runs
freely.
- The clamping collet and union nut must show
no signs of damage.
- Cracked or distorted cutters must not be used.
Wear suitable protection such as
ear protection, safety goggles, a
dust mask for work which gener-
ates dust, and protective gloves
when working with raw materials
and when changing tools.
- Festool electric power tools should only be
installed in work benches specially designed
by Festool. The electric power tool may become
unsafe and cause serious accident if installed
in benches from other manufacturers or self-
manufactured work benches.
3 Noise and vibration information
The typical values determined in accordance with
EN 60745 are:
Sound-pressure level/sound-power level
OF 1010 EBQ, OF 1010 EQ 79/90 dB(A)
Measuring uncertainty allowance K = 3 dB
Wear ear protection!
Overall vibration levels (vector sum for three di-
rections) measured in accordance with EN 60745:
Vibration emission level (3-axis) a
h
= 5.5 m/s
2
Front handle a
h
= 8,0 m/s
2
Uncertainty K = 2,0 m/s²
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
To Next Page
Loading...
