4 Technical data
Router OF 1400 EBQ
Power consumption 1400 W
Speed 10,000–
22,500 rpm
Max. speed (no-load) 23,000 rpm
Quick depth adjustment 70 mm
Fine depth adjustment 8 mm
Drive shaft connecting
thread
M22 x 1.0
cutter diameter Max. 63 mm
Weight as per EPTA pro
cedure 01:2014:
4.4 kg
5 Parts of the device
[1-1]
Depth stop scale
[1-2]
Indicator screw
[1-3]
Depth stop indicator
[1-4]
Routing depth fine adjustment
[1-5]
Handle/Height adjustment
[1-6]
Depth stop clamp lever
[1-7]
depth stop
[1-8]
Stepped stop
[1-9]
Router table
[1-10]
Speed adjusting wheel
[1-11]
Handle
[1-12]
On/off switch locking button
[1-13]
On/off switch
[1-14]
Spindle stop
[1-15]
Nut
[1-16]
Button for releasing the copying ring
The specified illustrations appear at the begin
ning of the Operating Instructions.
Accessories shown or described are not always
included in the scope of delivery.
6 Commissioning
WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V / 60 Hz
may be used.
CAUTION
Heating of the plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
► Connect and disconnect the mains power
cable [2].
6.1 Switching on/off
The switch
[1-13] is an on/off switch (press =
ON, release = OFF).
The on/off switch with the locking button [1-12]
can be engaged to operate in continuous mode.
Press the on/off switch again to release the
lock.
7 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel
[1-10] (see "Technical data").
This enables you to optimise the cutting speed
to suit the respective material.
Material Cutter diameter (mm) Recom
mended
cutting ma
terial
10–25 25–40 40–60
Adjusting wheel setting
Hardwood 6–4 5–3 3–1 HW (HSS)
Soft wood 6–5 6–3 4–1 HSS (HW)
English
16
To Next Page
Loading...
