Accessories
Guide Rail Attachment
The guide rail attachment is used to connect the router to
a Festool guide rail system for making straight cuts.
Assembling the Guide Rail Attachment
18 OF 1400 EQ Router
1. Before assembling the attachment, adjust the guide
rail gibs on both guide blocks.
a. Place the block on one of the ribs of the guide rail.
b. Tighten the two adjustment screws until the block
fits snuggly to the rib but still moves freely.
2. Thread the micro-adjust thumbwheel into either one
of the two guide blocks.
3. Place the other guide block over the free end of the micro-
adjust thumbwheel.
4. Insert the two guide rods through both guide blocks. Make
sure the rods stick out from the second block slightly.
5. Insert the guide rods through the eyelets in the router base.
To Next Page
Loading...
