9
Suspend
from wall [6]
Use wall peg
[2-1]
on rear side of device. Place on
nail or screw head which protrudes from a wall.
by rope [7]
Device can be suspended from a rope via the guid-
ing groove
[7-1]
located on handhold.
Extension Cord
If an extension cord is required, it must have suffi-
cient cross-section to prevent overheating or an ex-
cessive drop in voltage. An excessive drop in voltage
reduces the output and can lead to failure of the
motor. The table below shows you the correct cord
diameter as a function of the cord length for this
power tool.
Use only U.L. and CSA listed extension cords.
Never use two extension cords together. Instead,
use one long one.
L
The lower the AWG number, the stronger the
cord.
~1/8 in.
Ø ~7/16 in.
6
7-7/8“
Total extension cord
length (feet)
25 50 100 150
Cable size (AWG) 16 16 16 16
7
min.
33 lb.
7-1
7-7/8“
To Next Page
Loading...