Fetch Remote 3 - Reset remote to control Fetch Box only

7
Reset remote to control
Fetch Box only
5
Follow these steps if you want to clear the remote of the TV code programmed
through Simple or Direct Set Up.
Hold down and on the remote for 3 seconds. The remote flashes twice and backlights come on.
This will put the remote control into programming mode, where you’ll have 10 seconds to reset it..
Press the following buttons on your remote in order:
After you press the 9 button, then the 7 button and then the 7 button again,
the remote will flash four times.
If you want to program the Fetch remote to control your TV again, follow the
Simple Remote Set Up process. (page 3).
1
2
3