FIAMMASTORE
19
Read the following instructions and warnings carefully; failure to observe these installation and usage instructions
as well as the Highway Code in the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility.
Keep the original packaging to be used in case of return.
In the event of an accident involving the vehicle and/or the product, ensure that the product has not been
damaged. In the event of damage, contact your local retailer before moving the vehicle.
Fiamma declines every responsibility for any modification of the product that may cause damage and/or injury to
things and people.
Before installation, ensure compatibility with the vehicle on which the product must be installed.
Checking that the wall/rear door is sufficiently solid and suitable for guaranteeing the resistance of the anchoring
points is always mandatory. If this is not the case, tightness is not guaranteed and it will be necessary to reinforce
it.
Before leaving, make sure the awning is correctly closed. A damaged fabric does not allow the
awning to perfectly roll in. Never use the awning with a damaged fabric.
Periodically check the fixing condition of the brackets, especially after having travelled the first kilometres from
the installation and always before and after long trips, making sure that they have not moved and that the fixing is
correct.
The awnings are produced with a high quality standard, but some characteristics of the
materials (as little imperfections on paint or linearity of aluminium profiles; minor marks or light
strains of plastic parts), which could be interpreted as defects, come from the materials
and from the specific work processes, and take place even though Fiamma uses
advanced, innovative machinery and production and packaging techniques.
Apart from our strict quality controls, we also have our fabrics continuously checked by independent laboratories
to ensure that they are resistant to tear, to the pressure of water and to weather agents, and that their colours are
light-fast. To guarantee a perfect quality, the fabrics are waxed or laminated several times.
During this operation, single coloured pigments may move and thus create small bright spots in the material,
which are only irregularities that are technically unavoidable, but do not compromise the waterproofing of the
fabric.
MAINTENANCE INSTRUCTIONS
Make sure that your awning is completely dry and clean before closing it.
The remaining humidity could cause stains. If, however, you have no choice but closing the awning
when it is still wet, make sure to open it for drying within 12 hours maximum. Most dirt is superficial and can
be removed with water and a clean cloth or soft brush. If the fabric is very dirty, add some neutral detergent
(Marseille soap).
Never use any aggressive chemical and never clean the fabric with a high pressure machine. We recommend not
to use the awning at a temperature below 0°C.
It is recommended not to wash the outer casing of the awning with an aggressive product (or a rough cloth) that
could change the surface finishes or materials.
If the awning is more than 100 mm out of the vehicle shape, the presence of the awning must be
recorded in the vehicle’s registration documents (DIN 75303 - 2019).
EN
To Next Page
Loading...