100
WITH AN ARM-TYPE HOIST
Place the ends of the arms in the ares
shown in fig. 39 to raise the car.
Make sure that the arms
do not damage the body-
work of the car or the
side panels. Adjust the arms of
the hoist correctly and, if neces-
sary, insert a wooden or rubber
block in between.
fig. 39
P4E02195
fig. 38
P4E01731
Rib A of the car side member must
fit into groove B of the strip.
The car should not be
raised from the rear part
(chassis rear or suspen-
sion).
fig. 37
P4E01730
At the sides
The car may only be raised by plac-
ing the jack arm with the special brack-
et under the centre pillar fig. 37. Al-
ternatively, insert a strip of wood (di-
mensions in mm) fig. 38.
To Next Page
Loading...
