TECHNICAL SPECIFICATIONS
VEHICLE IDENTIFICATION NUMBER (VIN)
(The label is shown divided into two parts for reading
purposes)
It is applied to the left front pillar.
Vehicle Identification Number
NOTE:
It is illegal to remove or alter the VIN.
BRAKE SYS
TEM
Your vehicle is equipped with dual hydraulic brake
systems. If either of the two hydraulic systems lose
normal capability, the remaining system will still
function. However, there will be some loss of overall
braking effectiveness. You may notice increased pedal
travel during application, greater pedal force required
to slow or stop, and potential activation of the Brake
Syst
em Warning Light.
In the event power assist is lost f
or any reason (i.e.,
repeated brake applications with the engine off), the
brakes will still function. However, the effort required
to brake the vehicle will be much greater than that
required with the power system operating.
CAUTION!
If the Brake System Warning Light remains on
with the parking brake released, a brake system
malfunction is indicated. Have the brake system
serviced by an authorized dealer immediately.
WHEEL AND TIRE TORQUE
SPECIFICATIONS
Proper lug nut/bolt torque is very important to ensure
that the wheel is properly mounted to the vehicle. Any
time a wheel has been removed and reinstalled on the
vehicle, the lug nuts/bolts should be torqued using a
properly calibrated torque wrench using a high quality
six sided (hex) deep wall socket.
TORQUE SPECIFICATIONS
Lug Nut/Bolt Torque
**L
ug Nut/
Bolt Size
Lug Nut/
Bolt Socket
Size
88.5 Ft-Lbs (120 N·m) M12 x 1.25 17 mm
**Use only your authorized dealer recommended lug
nuts/bolts and clean or remove any dirt or oil before
tightening.
Inspect the wheel mounting surface prior to mounting
the tire and remove any corrosion or loose particles.
Wheel Mounting Surface
Tighten the lug nuts/bolts in the following pattern until
each nut/bolt has been tightened twice.
TECHNICAL SPECIFICATIONS 205
9
To Next Page
Loading...
