End-users and installers must be provided with
installation and operating instructions for satisfying RF
exposure compliance requirements. FCC ID information
to be provided on the product label: 6434C-BE2857,
2AHPN-BE2857, 2AHPN-BE2862 CANADA: Harman
International Industries, Inc. 30001 Cabot Drive Novi,
MI 48377 Model: R1 EXT NA 3B MY22, R1 EXT NA 3B
MY22, R1 INT NA 3B MY22 FCC Part 15.19 Labelling
requirements.
This device complies with part 15 of the FCC Rules
and Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference,
and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions
suivantes:
1. L'appareil ne doit pas produire de brouillage, et
2. FCC ID information to be provided on the
product label: 6434C-BE2857, 2AHPN-BE2857,
2AHPN-BE2862.
La operación de este equipo está sujeta a las
siguientes dos condiciones:
1. Es posible que este equipo o dispositivo no cause
interferencia perjudicial y
2. Este equipo o dispositivo debe aceptar cualquier
interferencia, incluyendo la que pueda causar su
operación no deseada.
RF Exposure Requirements
To comply with FCC RF exposure compliance
requirements, the device must be installed and
operated to provide a separation distance of at least
20 cm from all persons.
This equipment complies with Canada radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 20 cm between the
radiator and your body.
Déclaration d’exposition aux radiations
Cet équipement est conforme aux limites
d’exposition aux rayonnements ISED établies pour un
environnement non contrôlé. Cet équipement doit être
installé et utilisé avec un minimum de 20 cm de
distance entre la source de rayonnement et votre corps.
NOTE:
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE:
Remarque: Les changements ou modifications non
expressément approuvés par la partie responsable
de la conformité peuvent annuler l'autorisation de
l'utilisateur à utiliser l'équipement.
ACC and FCW — USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device must not cause interference, and
2. This device must accept any interference,
including interference that may cause undesired
operation of the device.
Changes or modifications made to this equipment not
expressly approved by Robert BOSCH GmbH may void
the FCC authorization to operate this equipment.
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
212 CUSTOMER ASSISTANCE
To Next Page
Loading...
