STARTING AND DRIVING
142
Release the brake pedal and switch
on ignition.
Depress and hold the brake pedal
and push the switch .
Release the brake pedal and switch
off ignition.
The deactivation will be confirmed by a
message and will be cancelled after 15
minutes. To previously return to normal
operation, depress the brake pedal and
start the engine.
FAULT
Failure mode of electric parking brake
is indicated by a lamp and by a
message displayed in the instrument
panel display.
The lamp flashes: electric parking
brake is not fully applied or released.
When continuously flashing, release
electric parking brake and retry
applying.
IMPORTANT
162)
Do not park the vehicle on an easily
ignitable surface. The high temperature
of the exhaust system could ignite the
surface. Always apply the parking brake.
If the vehicle is on a level surface or uphill
slope, set the PRND command to position
P. If the vehicle is on a downhill slope,
set the PRND command to position P.
Turn the front wheels towards the kerb.
Close the windows. Switch off the engine.
Remove the ignition key from the ignition
switch or switch off ignition on vehicles
with STOP START ENGINE button. Turn
the steering wheel until the steering wheel
lock is felt to engage.
163)
Pull switch for a minimum of
1 second until control indicator
illuminates constantly and electric parking
brake is applied. The electric parking brake
operates automatically with adequate
force. Before leaving the vehicle, check the
electric parking brake status.
ELECTRIFIED
DUAL CLUTCH
AUTOMATIC
TRANSMISSION
(Hybrid versions)
6-speed electrified dual-clutch
automatic gearbox with push selector
for hybrid vehicles. It also offers a
manual mode with gear changes via
control paddles located behind the
steering wheel. It includes the 48 V
electric motor, which improves the
performance of the petrol engine,
reduces fuel consumption and drives in
all-electric.
GEAR SELECTION
164) 165) 166)
50)
170 F6S0215
Push the buttons fig. 170:
(P) park position, wheels are locked,
engage only when the vehicle is
stationary, engaged automatically when
driver's door is opened or engine is
switched off
(R) reverse gear, engage only when the
vehicle is stationary
(N) neutral
(D) automatic mode (first push)
(M) manual mode (second push)
The mode or selected gear is shown
in the instrument panel display (1)
fig. 174.
To Next Page
Loading...
