EasyManua.ls Logo

Fiat 600 2024 - Heated Windscreen

Fiat 600 2024
336 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
53
minutes the first time it is activated. The
following activations have a duration of
5 minutes.
If this function is provided, pressing
the button REAR also activates
demisting/defrosting of door mirrors
and heated vents (where provided).
WARNING Do not apply stickers to the
inside of the heated rear window over
the heating filaments, to avoid damage
that might cause them to stop working
properly.
HEATED WINDSCREEN
(where provided)
In cold weather, this system heats
the bottom of the windscreen, as well
as the area alongside the left-hand
windscreen pillar fig. 81.
81 F6S0047
Without changing the settings for the
air conditioning system, it allows faster
release of the windscreen wiper blades
when they are frozen to the windscreen
and helps avoid the accumulation of
snow resulting from the operation of
the windscreen wipers.
Push the button (1) fig. 82 to activate
the windscreen heating. The warning
light on the button comes on to
indicate that it has been turned on.
Push the button again to switch off.
82 F6S0054
The function is activated when the
outside temperature drops below 0°C.
It is deactivated automatically when the
engine is switched off.
SWITCHING THE
CLIMATE CONTROL
SYSTEM OFF/ON
Switching off the climate control
system
Press the A/C button (8) fig. 80.
With climate control system off:
air recirculation is on, thus isolating
the passenger compartment from the
outside;
the compressor is off;
the fan is off;
the heated rear window can be
activated/deactivated.
Switching off the climate control
system
To turn the climate control system off
press the OFF button (9) fig. 80.
Switching on the climate control
system
To turn the climate control system back
on press the A/C button (8) fig. 80.
HEATER
The heater activates automatically
depending on the environmental
conditions and with ignition device in
the position 2 or with the STOP START
ENGINE button in position START.

Table of Contents

Related product manuals