14 Nero 603 83 540 Connect DOBLO GB
CONNECT Nav
14
Manual switching on
With ignition key at STOP press
knob 16-fig. 1, to switch the system
on, thus making available the following
modules:
– MAIN,
– AUDIO,
– NAV,
– TEL,
– Targasys
•
.
IMPORTANT In this mode, the
SETUP and TRIP modules can be ac-
tivated; however, it will not be possi-
ble to validate any operation con-
cerning parameter change, language
change, units change and any other
type of adjustment provided by the
system. These limitations are normal
when switching the system on manu-
ally by the knob 16-fig. 1, since with
engine off (key at STOP) the vehicle
data transmission devices are not op-
erating.
Turning the ignition key to MAR, will
make all system functions active.
SYSTEM POWER OFF
The CONNECT system can be
switched off according to two differ-
ent modes:
– deactivation independent of ig-
nition key
– deactivation dependent on ig-
nition key
To choose the power-off mode, see
the Power OFF submenu in the SET-
UP menu.
Deactivation independent
of ignition key
With this mode active, the system
can be turned off by pressing the knob
16-fig. 1.
The display will show the message
“PLEASE WAIT WHILE SYSTEM
TURNS OFF”.
IMPORTANT With ignition key at
STOP, deactivation is delayed and will
take place after 20 minutes if the sys-
tem has a destination set or a phone
call is in progress.
Deactivation dependent
on ignition key
With this mode active, the system
can be switched off by turning the ig-
nition key to STOP or pressing the
knob 16-fig. 1.
IMPORTANT Deactivation with
ignition key to STOP is delayed and
will take place after 20 minutes if the
system has a destination set or a
phone call is in progress.
To Next Page
Loading...
