FREEMONT
Vehicle towing/lifting
5.1 Towing attachment points
The tow ring is provided with the car.
Fastening the tow ring
• Remove the rubber cap from the front bumper or open the flap
on the rear bumper;
• take the tow ring A from its housing in the tool support;
• fully screw the hook onto the threaded front or rear pin.
5.2 General warnings for towing
Before towing, make sure that the tow ring is fully tightened.
If the car to be towed needs to be steered, the ignition device must
be set to RUN or ACC but not to LOCK/OFF.
5. Vehicle towing/lifting
To Next Page
Loading...
