14
HANDS-FREE KIT WITH VOICE RECOGNITION AND
Bluetooth
®
WIRELESS TECHNOLOGY
SOUND SYSTEM
LOUDNESS FUNCTION
The Loudness function improves the
sound volume when listening at low lev-
el, increasing the basses and trebles.
To switch the function on/off, keep but-
ton AUDIO-LD pressed until hearing the
beep. The function condition (on or off) is
shown on the display for few seconds by
“LOUDNESS ON” or “LOUDNESS
OFF”.
HANDS-FREE KIT
If the hands-free kit is installed on the car,
when a phone call is received the radio au-
dio is connected to the phone input, mut-
ing the radio or the CD. The telephone
sound is always heard with a fixed volume,
but it can be adjusted during the conver-
sation by button/knob ON/ OFF.
The fixed telephone volume can be ad-
justed through the “VOICE” function of
the menu (see paragraph “MENU”).
While the sound is off for a phone call, the
display shows the word “HELLO!”.
Call audio will be muted when receiving
an emergency alarm.
During a phone call with ignition key at
STOP, the sound system will not switch
off automatically after 20 minutes but on-
ly at the end of the call.
FADER ADJUSTMENT
Proceed as follows:
❒
briefly and repeatedly press button AU-
DIO-LD until the display shows “FAD-
ER” (select Fader function);
❒
press button
N
to increase the sound
from the rear speakers or button
O
to
increase the sound from the front
speakers.
Pressing the buttons briefly the change is
gradual by steps. Pressing longer, changing
is faster.
Select “CENTER” to set the same value
for both front and rear speakers.
To Next Page
Loading...
